International Journal of Engineering

International Journal of Engineering

Experimental and Numerical Investigations for Improvement of Building Ventilation Performance by Using Solar Chimney Integrated with Different Phase Change Materials and Nanoparticles

Document Type : Original Article

Authors
Faculty of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
Abstract
A detailed experimental and numerical investigation of a constructed solar chimney (SC) model and its thermal performance is presented, conducted under the climatic conditions of Al-Kut City, Iraq. This study focuses on the thermal performance of two vertical solar chimneys oriented towards the south and west directions. The first configuration consists of a building with two vertical solar chimneys, incorporating two types of phase change materials (PCMs): Al-Dura paraffin wax and block-shaped paraffin wax (PCM1) and (PCM2), respectively. These PCMs are placed in the same aluminum container, separated by partitions, and equipped with fins to enhance the thermal contact area. In the second configuration, conductive mono nanoparticles (NP), specifically aluminum oxide (Al2O3), were introduced into both (PCM1) and (PCM2) at a volume fraction of approximately 1.6% to improve the thermal characteristics of the paraffin and overall heat storage performance. The study investigates the role of paraffin wax as an energy storage medium along with nanoparticles, where the PCM stores thermal solar energy during the day and discharges it at night through the phase change process. Numerical results demonstrate that the PCMs significantly affect air change per hour (ACH) during the day and extend ventilation hours post-sunset. The second configuration showed an ACH improvement of approximately 5.35% and a reduction in room temperature by 4.7°C compared to the first case. Experimental results indicated a 5.2% improvement in ACH and a decrease of 3.9°C in room temperature. Both experimental and numerical results confirm that integrating nanofluids with PCM significantly enhances the overall efficiency of the solar chimney. The novelty of this study lies in the innovative integration of phase change materials with conductive nanoparticles, which not only enhances the thermal performance but also significantly extends ventilation periods, especially under the high solar radiation conditions typical of AL-Kut city, Iraq. Finally, due to the intense solar radiation in AL-Kut, the passive ventilation rates achieved by the solar chimney were found to be highly satisfactory.

Graphical Abstract

Experimental and Numerical Investigations for Improvement of Building Ventilation Performance by Using Solar Chimney Integrated with Different Phase Change Materials and Nanoparticles
Keywords

Subjects


  1. Rezaie B, Reddy BV, Rosen MA. Exergy analysis of thermal energy storage in a district energy application. Renewable Energy. 2015;74:848-54. https://doi.org/10.1016/j.renene.2014.09.014
  2. Sadafi M, Hosseini R, Safikhani H, Bagheri A, Mahmoodabadi M. Multi-objective optimization of solar thermal energy storage using hybrid of particle swarm optimization and multiple crossover and mutation operator. International Journal of Engineering Transactions B: Applications. 2011;24:366-76. https://doi.org/10.5829/idosi.ije.2011.24.04b.07
  3. BAGHERI TH, Moradi M, BAGHERI TF. New technique for global solar radiation forecast using bees algorithm. International Journal of Engineering Transactions B: Applications. 2013;26:1385-92. https://doi.org/10.5829/idosi.ije.2013.26.11b.14
  4. Ajay K, Kundan L. Performance evaluation of nanofluid (al2o3/h2o-c2h6o2) based parabolic solar collector using both experimental and cfd techniques. International Journal of Engineering-Transactions A: Basics. 2016;29(4):572-80. https://doi.org/10.5829/idosi.ije.2016.29.04a.17
  5. Bassiouny R, Koura NS. An analytical and numerical study of solar chimney use for room natural ventilation. Energy and buildings. 2008;40(5):865-73. https://doi.org/10.1016/j.enbuild.2007.06.005
  6. Bassiouny R, Korah NS. Effect of solar chimney inclination angle on space flow pattern and ventilation rate. Energy and Buildings. 2009;41(2):190-6. https://doi.org/10.1016/j.enbuild.2008.08.009
  7. Karimipour-Fard P, Beheshti H. Performance enhancement and environmental impact analysis of a solar chimney power plant: Twenty-four-hour simulation in climate condition of isfahan province, iran. International Journal of Engineering Transactions B: Applications. 2017;30(8):1260-9. https://doi.org/10.5829/ije.2017.30.08b.20
  8. Majeed MH, Ali A. Passive solar heating of a space. IOSR Journal of Mechanical and Civil Engineering. 2016;13(6):101-7. https://doi.org/10.9790/1684-130605101107
  9. Jubear AJ, Ghareer AD. Numerical investigations on solar chimney inclination angle for room ventilation. International Journal of Engineering & Technology. 2018;7(4.17):1-9.
  10. Kaneko Y, Sagara K, Yamanaka T, Kotani H, Sharma S, editors. Ventilation performance of solar chimney with built-in latent heat storage. Proceedings of 10th international conference of thermal energy conference (ECOSTOCK); 2006.
  11. Amori KE, Mohammed SW. Experimental and numerical studies of solar chimney for natural ventilation in Iraq. Energy and Buildings. 2012;47:450-7. https://doi.org/10.1016/j.enbuild.2011.12.014
  12. Imran AA, Jalil JM, Ahmed ST. Induced flow for ventilation and cooling by a solar chimney. Renewable energy. 2015;78:236-44. https://doi.org/10.1016/j.renene.2015.01.019
  13. Chung LP, Ahmad MH, Ossen DR, Hamid M. Effective solar chimney cross section ventilation performance in Malaysia terraced house. Procedia-Social and Behavioral Sciences. 2015;179:276-89. https://doi.org/10.1016/j.sbspro.2015.02.431
  14. Li Y, Liu S. Experimental study on thermal performance of a solar chimney combined with PCM. Applied Energy. 2014;114:172-8. https://doi.org/10.1016/j.apenergy.2013.09.022
  15. Assari M, Basirat Tabrizi H, Parvar M, Alkasir Farhani M. Experimental investigation of sinusoidal tube in triplex-tube heat exchanger during charging and discharging processes using phase change materials. International Journal of Engineering Transactions A: Basics, . 2019;32(7):999-1009. https://doi.org/10.5829/IJE.2019.32.07A.13
  16. Krishna J, Kishorea P, Solomonb AB, Sharmac VK. Experimental and Numerical Investigations on Al2O3–Tricosane Based Heat Pipe Thermal Energy Storage. International Journal of Engineering Transactions C: Aspects. 2018;31:980-5. https://doi.org/10.5829/IJE.2018.31.06C.16
  17. Jadidi A, Jadidi M. An algorithm based on predicting the interface in phase change materials. International Journal of Engineering Transactions B: Applications. 2018;31(5):799-804. https://doi.org/10.5829/ije.2018.31.05b.15
  18. Vandrangi S, Hassan S, Sharma K, Baheta A. Heat Transfer Coefficients Investigation for TiO2 Based Nanofluids. International Journal of Engineering, Transactions A: Basics. 2019;32:1491-6. https://doi.org/10.5829/ije.2019.32.10a.19
  19. Tiji ME, Eisapour M, Yousefzadeh R, Azadian M, Talebizadehsardari P. A numerical study of a PCM-based passive solar chimney with a finned absorber. Journal of Building Engineering. 2020;32:101516. https://doi.org/10.1016/j.jobe.2020.101516
  20. Selvana J, Manavalla S. An Innovative and Reliable Hybrid Cooling Method for Electric Vehicle Motors. International Journal of Engineering Transactions A: Basics 2024;37(07):1263. https://doi.org/10.5829/IJE.2024.37.07A.06
  21. Ali MH, Mawlood MK, Jalal RE. Investigation of the performance of a newly designed solar chimney for enhancing natural ventilation and mitigation of summer overheating. Journal of Building Engineering. 2024;95:110310. https://doi.org/10.1016/j.jobe.2024.110310
  22. Huang S, Li W, Lu J, Li Y, Wang Z, Zhu S. Experimental study on thermal performances of a solar chimney with and without PCM under different system inclination angles. Energy. 2024;290:130154. https://doi.org/10.1016/j.energy.2023.130154
  23. Saleh MJ, Ahmed OK, Atallah FS. Comparison assessment for the effect of porous media and phase change material on the performance of photovoltaic solar chimney. Journal of Energy Storage. 2024;98:113158. https://doi.org/10.1016/j.est.2024.113158
  24. Nia ES, Ghazikhani M. Enhancing reliability and efficiency of solar chimney by phase change material Integration: An Experimental study. Thermal Science and Engineering Progress. 2024;51:102600. https://doi.org/10.1016/j.tsep.2024.102600
  25. Sornek K, Figaj R, Papis-Frączek K. Development and tests of the novel configuration of the solar chimney with sensible heat storage. Applied Thermal Engineering. 2025;258:124515. https://doi.org/10.1016/j.applthermaleng.2024.124515
  26. Hassan HZ. Performance enhancement of the basic solar chimney power plant integrated with an adsorption cooling system with heat recovery from the condenser. Energies. 2023;17(1):136. https://doi.org/10.3390/en17010136
  27. Qasim HH, Alshara AK, Abood FA. Simulation and design of a solar chimney integrated with phase change material layer for building ventilation. International Journal of Thermofluids. 2024;24:100853. https://doi.org/10.1016/j.ijft.2024.100853
  28. ALubaidi AB, Abas FO, Abass RA, Abdulredhi NJ. Thermal Behaviour of Paraffin Wax/Poly Vinyl Alcohol Composite Material. Al-Khwarizmi Engineering Journal. 2016;12(2):18-26.
  29. Li C, Li Q, Ge R. Fabrication and investigation of paraffin based shape-stable composite phase change materials with styrene ethylene butylene styrene as supporting skeleton for low temperature thermal energy storage and management. Journal of Energy Storage. 2023;68:107802. https://doi.org/10.1016/j.est.2023.107802
  30. Alawi OA, Sidik NAC, Xian HW, Kean TH, Kazi SN. Thermal conductivity and viscosity models of metallic oxides nanofluids. International Journal of Heat and Mass Transfer. 2018;116:1314-25. https://doi.org/10.1016/j.ijheatmasstransfer.2017.09.133
  31. Daood IY. Effects of nano-fluids types, volume fraction of nano-particles, and aspect ratios on natural convection heat transfer in right-angle triangular enclosure. Eng And Tech Journal. 2010;28(16):5365-88.