Investigation of Antifouling Paints for Vessel in Tropical Seawater of North Jakarta in Indonesia

Document Type : Original Article

Authors

1 Research Center for Metallurgy, National Research and Innovation Agency, Bld.720, Serpong, Tangerang Selatan, Banten, Indonesia

2 Research Center for Applied Microbiology, National Research and Innovation Agency, Jakarta-Bogor No.KM 46, Pakansari, Cibinong, Bogor, Jawa Barat, Indonesia

Abstract

The copper-based biocide is mostly used as primary additive of Antifouling (AF) paint in Indonesia especially on vessels. The evaluation for the efficacy of AF paint was conducted where anti corrosion (AC) paint was also as a reference. The panels with both paints were exposed to various sea depths of up to 3 meters until 12 months of exposures. The measurement of parameters of seawater consisting of water conductivity, pH, temperature, dissolved oxygen and salinity were carried out. There was no or less attached marine biofouling on AF-painted panels but not on AC-painted panels up to 12-months of field exposure in various sea depths. There was no difference between the properties of AF paints before and after exposure to various sea depths. The inhibitive performance of AF paint depends on the existence of AF layer containing Cu2O biocide where the thickness of that layer decreases in increase of time exposure.

Keywords

Main Subjects

References

  1. Priyotomo G, Nuraini L, Prifiharni S. A short review of antifouling paint perfomance in tropical seawater of Indonesia. Research & Development in Material Science. 2018;8(4). https://doi.org/10.31031/rdms.2018.08.000695
  2. Peres RS, Armelin E, Moreno-Martinez JA, Aleman C, Ferreira CA. Transport and antifouling properties of papain-based antifouling coatings. Applied Surface Science. 2015;341:75-85. https://doi.org/10.1016/j.apsusc.2015.03.004
  3. Ytreberg E, Bighiu MA, Lundgren L, Eklund B. XRF measurements of tin, copper and zinc in antifouling paints coated on leisure boats. Environmental Pollution. 2016;213:594-9. https://doi.org/10.1016/j.envpol.2016.03.029
  4. Nuraini L, Prifiharni S, Priyotomo G, Sundjono S, Gunawan H, editors. Evaluation of anticorrosion and antifouling paint performance after exposure under seawater Surabaya–Madura (Suramadu) bridge. AIP Conference Proceedings; 2017: AIP Publishing.
  5. Schwindt E, Gappa JL, Raffo MP, Tatián M, Bortolus A, Orensanz JM, et al. Marine fouling invasions in ports of Patagonia (Argentina) with implications for legislation and monitoring programs. Marine Environmental Research. 2014;99:60-8. https://doi.org/10.1016/j.marenvres.2014.06.006
  6. Lord JP, Calini JM, Whitlatch RB. Influence of seawater temperature and shipping on the spread and establishment of marine fouling species. Marine Biology. 2015;162:2481-92. https://doi.org/10.1007/s00227-015-2737-2
  7. Ferry M, Wan Nik W, Mohd Noor CW. The influence of seawater velocity to the corrosion rate and paint degradation at mild steel plate immersed in sea water. Applied Mechanics and Materials. 2014;554:218-21. https://doi.org/10.4028/www.scientific.net/AMM.554.218
  8. Little BJ, Lee JS, Ray RI. The influence of marine biofilms on corrosion: a concise review. Electrochimica Acta. 2008;54(1):2-7. https://doi.org/10.1016/j.electacta.2008.02.071
  9. Li L, Mahmoodian M, Li CQ. Effect of corrosion on mechanical properties of steel bridge elements. Maintenance, Safety, Risk, Management and Life-Cycle Performance of Bridges. 2018:1783-90. https://doi.org/10.1201/9781315189390-243
  10. Li S, Dong H, Shi L, Li P, Ye F. Corrosion behavior and mechanical properties of Al-Zn-Mg aluminum alloy weld. Corrosion Science. 2017;123:243-55. https://doi.org/10.1016/j.corsci.2017.05.007
  11. Almeida E, Diamantino TC, de Sousa O. Marine paints: the particular case of antifouling paints. Progress in organic coatings. 2007;59(1):2-20. https://doi.org/10.1016/j.porgcoat.2007.01.017
  12. Turner A. Marine pollution from antifouling paint particles. Marine pollution bulletin. 2010;60(2):159-71. https://doi.org/10.1016/j.marpolbul.2009.12.004
  13. Azemar F, Faÿ F, Réhel K, Linossier I. Development of hybrid antifouling paints. Progress in Organic Coatings. 2015;87:10-9. https://doi.org/10.1016/j.porgcoat.2015.04.007
  14. Yebra DM, Kiil S, Dam-Johansen K. Antifouling technology—past, present and future steps towards efficient and environmentally friendly antifouling coatings. Progress in organic coatings. 2004;50(2):75-104. https://doi.org/10.1016/j.porgcoat.2003.06.001
  15. Amal M, Wibowo J, Nuraini L, Senopati G, Hasbi M, Priyotomo G, editors. Antibacterial activity of copper oxide nanoparticles prepared by mechanical milling. IOP Conference Series: Materials Science and Engineering; 2019: IOP Publishing.
  16. Carteau D, Vallée-Réhel K, Linossier I, Quiniou F, Davy R, Compère C, et al. Development of environmentally friendly antifouling paints using biodegradable polymer and lower toxic substances. Progress in Organic Coatings. 2014;77(2):485-93. https://doi.org/10.1016/j.porgcoat.2013.11.012
  17. Liu C. Development of anti-fouling coating using in marine environment. Int J Environ Monit Anal. 2015;3:373. https://doi.org/10.11648/j.ijema.20150305.30
  18. Nuraini L, Prifiharni S, Priyotomo G, editors. The corrosivity and performance evaluation of antifouling paint exposed in seawater Muara Baru Port, Jakarta. Journal of Physics: Conference Series; 2017: IOP Publishing.
  19. Priyotomo G, Nuraini L, Gunawan H, Triwardono J, Sundjono S, Prifiharni S. A Preliminary field study of antifouling paint perfomance after short exposure in Mandara Bali, Indonesia. International Journal of Engineering, Transactions A: Basics,. 2021;34(4):976-86. https://doi.org/10.5829/ije.2021.34.04a.24
  20. Jaić M, Palija T. High gloss finish: The impact of surface roughness on gloss. Zaštita materijala. 2015;56(4):457-62. https://doi.org/10.5937/zasmat1504457j
  21. Fukumasu NK, Souza RM. Numerical evaluation of cohesive and adhesive failure modes during the indentation of coated systems with compliant substrates. Surface and Coatings Technology. 2014;260:266-71. https://doi.org/10.1016/j.surfcoat.2014.07.093
  22. Amara I, Miled W, Slama RB, Ladhari N. Antifouling processes and toxicity effects of antifouling paints on marine environment. A review. Environmental toxicology and pharmacology. 2018;57:115-30. https://doi.org/10.1016/j.etap.2017.12.001
  23. Rodriguez SGS, Sithole N, Dhakal N, Olive M, Schippers JC, Kennedy MD. Monitoring particulate fouling of North Sea water with SDI and new ASTM MFI0. 45 test. Desalination. 2019;454:10-9. https://doi.org/10.1016/j.desal.2018.12.006
  24. Le Menn M, Albo PAG, Lago S, Romeo R, Sparasci F. The absolute salinity of seawater and its measurands. Metrologia. 2018;56(1):015005. https://doi.org/10.1088/1681-7575/aaea92
  25. Wouthuyzen S, Tarigan S, Kusmanto E, Supriyadi HI, Sediadi A. Measuring sea surface salinity of the Jakarta bay using remotely sensed of ocean color data acquired by modis sensor. Marine Research in Indonesia. 2011;36(2):51-70. https://doi.org/10.14203/mri.v36i2.41
  26. Kale VS. Consequence of temperature, pH, turbidity and dissolved oxygen water quality parameters. International Advanced Research Journal in Science, Engineering and Technology. 2016;3(8):186-90.
  27. Leidonald R, Muhtadi A, Lesmana I, Harahap Z, Rahmadya A, editors. Profiles of temperature, salinity, dissolved oxygen, and pH in Tidal Lakes. IOP Conference Series: Earth and Environmental Science; 2019: IOP Publishing.
  28. Jaud T, Dragon A-C, Garcia JV, Guinet C. Relationship between chlorophyll a concentration, light attenuation and diving depth of the southern elephant seal Mirounga leonina. 2012. https://doi.org/10.1371/journal.pone.0047444
  29. Assiry A, Gaily M, Alsamee M, Sarifudin A. Electrical conductivity of seawater during ohmic heating. Desalination. 2010;260(1-3):9-17. https://doi.org/10.1016/j.desal.2010.05.015
  30. Holm ER, Kavanagh CJ, Meyer AE, Wiebe D, Nedved BT, Wendt D, et al. Interspecific variation in patterns of adhesion of marine fouling to silicone surfaces. Biofouling. 2006;22(4):233-43. https://doi.org/10.1080/08927010600826129
  31. Swain GW, Kovach B, Touzot A, Casse F, Kavanagh CJ. Measuring the performance of today’s antifouling coatings. Journal of Ship Production. 2007;23(03):164-70. https://doi.org/10.5957/jsp.2007.23.3.164
  32. Takahashi K. Release rate of biocides from antifouling paints. Ecotoxicology of antifouling biocides. 2009:3-22. https://doi.org/10.1007/978-4-431-85709-9_1
International Journal of Engineering
Volume 37, Issue 1
TRANSACTIONS A: Basics
January 2024
Pages 167-177

Files

Share

How to cite

Statistics