Full Characterization of Sarcheshmeh and Khatoon-Abad Copper Anode Slimes: Characterization Impact on the Decopperization Operation

Document Type : Original Article

Authors

School of Metallurgy and Materials Engineering, College of Engineering, University of Tehran, Tehran, Iran

Abstract

Copper anode slime, a valuable by-product generated during the electrorefining process, is an important secondary resource for the recovery of metals, such as gold, silver, selenium, tellurium, PGMs and copper. A full characterization of the anode slime is an essential part of the efficient recovery of these valuable metals. In this research, the refinery slimes of the Sarcheshmeh and Khatoon-Abad copper complexes, were fully characterized and compared using inductively coupled plasma (ICP), X-ray diffraction (XRD), X-ray fluorescence (XRF), scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS), thermogravimetric analysis (TGA), differential thermal analysis (DTA), and particle size analysis. Besides the bottom cell slime characterization, properties of the Sarcheshmeh’s adherent slime was also analyzed and correlated. Sarcheshmeh copper slime particle size was found much smaller than the Khatoon-Abad slime. For both slimes though, the major part the gold and tellurium are located in larger than 38-micron particles. The main difference in thermal analysis of the two slime samples was originated from their selenium content difference. This has caused the higher concentration of non-selenide copper compounds at Khatoon-Abad slime, resulted in its easier copper recovery. Decopperization of both bottom-cell slimes were investigated and a significant difference in copper dissolution behaviors of the two slimes were observed due to their characteristic difference including the copper-selenide phases and capsulated copper in the barium sulfate agglomerates. Copper dissolution from Khatoon-Abad slime was observed to reach 90% comparing to 40% for Sarcheshmeh slime using atmospheric leaching.

Keywords

Main Subjects

References

  1. Xiao, L., Wang, Y.L., Yu, Y., Fu, G.Y., Han, P.W., Sun, Z.H.I., and Ye, S.F., “An Environmentally Friendly Process to Selectively Recover Silver from Copper Anode Slime.” Journal of Cleaner Production, Vol. 187, No. 20, (2018), 708-716, doi: 10.1016/j.jclepro.2018.03.203.
  2. Liu, W., Yang, T., Zhang, D., Chen, L., and Liu, Y., “Pretreatment of Copper Anode Slime with Alkaline Pressure Oxidative Leaching.” International Journal of Mineral Processing, Vol. 128, No. 10, (2014), 48-54, doi: 10.1016/j.minpro.2014.03.002.
  3. Bäckström, J., “Copper, Nickel and Tellurium Yields during Leaching of Anode Slime.” Master Thesis, Lulea University of Technology, (2010).
  4. Mahmoudi, A., Shakibania, S., Mokmeli, M., and Rashchi, F, “Tellurium, from Copper Anode Slime to High Purity Product: A Review Paper.” Metallurgical and Materials Transactions B, Vol. 51, No. 6, (2020), 2555-2575, doi: 10.1007/s11663-020-01974-x.
  5. Chen, T.T., and Dutrizac, J.E., “Mineralogical Characterization of Anode Slimes-IV. Copper-Nickel-Antimony Oxide (“Kupferglimmer”) in CCR Anodes and Anode Slimes.” Canadian Metallurgical Quarterly, Vol. 28, No. 23, (1989), 127-134, doi: 10.1179/cmq.1989.28.2.127.
  6. Chen, T.T., and Dutrizac, J.E., “The Mineralogy of Copper Electrorefining.” The Journal of the Minerals, Metals & Materials Society, Vol. 42, No. 32, (1990), 39-44 doi: 10.1007/BF03221053.
  7. Chen, T.T., and Dutrizac, J.E., “Mineralogical Characterization of Anode Slimes: Part 7-Copper Anodes and Anode Slimes from the Chuquicamata Division of Codelco-Chile.” Canadian Metallurgical Quarterly, Vol. 30, No. 12, (1991), 95-106 doi: 10.1179/cmq.1991.30.2.95.
  8. Chen, T.T., and Dutrizac, J.E. “A Mineralogical Study of the Deportment and Reaction of Silver during Copper Electrorefining.” Metallurgical and Materials Transactions B, 20, No. 11, (1989), 345-361, doi: 10.1007/BF02696987.
  9. Chen, T. T., and Dutrizac, J.E., “Mineralogical Characterization of Anode Slimes: Part V-Nickel-Rich Copper Anodes from the CCR Division of Noranda Minerals Inc.” Canadian Metallurgical Quarterly, Vol. 29, No. 8, (1990), 27-37, doi: 10.1179/cmq.1990.29.1.27.
  10. Chen, T.T., and Dutrizac, J.E., Mineralogical Characterization of Anode Slimes: Part 10. Tellurium in Raw Anode Slimes. Canadian Metallurgical Quarterly, Vol. 35, No. 54, (1996), 337-351, doi: 10.1179/cmq.1996.35.4.337.
  11. Chen, T.T., and Dutrizac, J.E., “Mineralogical Characterization of Anode Slimes: Part 8-Silica in Copper Anodes and Anode Slimes.” Canadian Metallurgical Quarterly, Vol. 30, No. 7, (1991), 173-185, doi: 10.1179/cmq.1991.30.3.173.
  12. Chen, T.T., and Dutrizac, J.E. “Mineralogical Characterization of a Copper Anode and the Anode Slimes from the La Caridad Copper Refinery of Mexicana De Cobre.” Metallurgical and Materials Transactions B, 36, No. 41, (2005), 229-240 doi: 10.1007/s11663-005-0024-1.
  13. Habashi, F., A Textbook of Hydrometallurgy. Metallurgie Extractive: Quebec, 1999.
  14. Chen, T.T., and Dutrizac, J.E., “The Mineralogical Characterization of Tellurium in Copper Anodes.” Metallurgical and Materials Transactions B, 24, No. 11, (1993), 997-1007, doi: 10.1007/BF02660991.
  15. Chen, T.T., and Dutrizac, J.E., “Mineralogical Characterization of Anode Slimes-I. Anode Copper from Inca’s Copper Cliff Copper Refinery.” Canadian Metallurgical Quarterly, Vol. 27, No. 8, (1988), 91-96, doi: 10.1179/cmq.1988.27.2.91.
  16. Schlesinger, M.E., Sole, K.C., and Davenport, W.G., Extractive Metallurgy of Copper. Oxford: Elsevier Science, 2011.
  17. Kiviluoma, M., Aaltonen, M., Aromaa, J., Lundström, and M., Forsén, O., “Development of Characterization Methods for Adherent Anode Slimes in Copper Electrorefining.”, Physicochemical Problems of Mineral Processing, Vol. 52, No. 1, (2016), 295-302, doi: 10.5277/ppmp160125
  18. Wang, X., Chen, Q., Yin, Z., Wang, M., and Zhang, F., “Homogeneous Precipitation of As, Sb and Bi Impurities in Copper Electrolyte During Electrorefining.” Hydrometallurgy, Vol. 105, No. 12, (2011), 355-358, doi: 10.1016/j.hydromet.2010.10.004.
  19. Mokmeli, M., “Pre-feasibility Study in Hydrometallurgical Treatment of Low-Grade Chalcopyrite Ores from Sarcheshmeh Copper Mine.” Hydrometallurgy, Vol. 191, No. 105215, (2020), doi: 10.1016/j.hydromet.2019.105215.
  20. Dehghanpoor, M.H., Zivdar, M., and Torabi, M., “Extraction of Copper and Gold from Anode Slime of Sarcheshmeh Copper Complex.” Journal of the Southern African Institute of Mining and Metallurgy, Vol. 116, No. 17, (2016), 1153-1157, doi: 10.17159/2411-9717/2016/v116n12a9.
  21. Khanlarian, M., Rashchi, F, and Saba, M., “A Modified Sulfation-Roasting-Leaching Process for Recovering Se, Cu, and Ag from Copper Anode Slimes at a Lower Temperature.” Journal of Environmental Management, Vol. 235, No. 45, (2019), 303-309, doi: 10.1016/j.jenvman.2019.01.079.
  22. Saeedi, M., Alamdari, E.K., Darvishi, D., and Alamdari, A.K., “Chlorine Leaching of Au from Copper Anode Slimes using the Response Surface Method in an Agitated Reactor.’ Mineral Processing and Extractive Metallurgy, 124, No. 8, (2015), 9-15, doi: 10.1179/1743285514Y.0000000071.
  23. Abdollahy, M., Shafaei, S.Z. “Optimized Leaching Conditions for Selenium from Sar-Cheshmeh Copper Anode Slimes.” Iranian Journal of Chemistry and Chemical Engineering, Vol. 23, No. 11, (2004), 101-108, doi: 10.30492/ijcce.2004.8144
  24. Ranjbar, R., Naderi, M., Omidvar, H., and Amoabediny, G. “Gold Recovery from Copper Anode Slime by Means of Magnetite Nanoparticles (MNPs).” Hydrometallurgy, Vol. 143, No. 12, (2014), 54-59, Vol: 10.1016/j.hydromet.2014.01.007.
  25. Zahedi, H., Mollahosseini, A., and Noroozian, E. “Synthesis Silver Nanoparticles by Recovery Silver from Anode Slime of Kerman Sarcheshmeh Cooper Complex.” International Journal of Bio-Inorganic Hybrid Nanomaterials, Vol. 4, No. 1, (2015), 15-19.
  26. Ranjbar, R., Naderi, M., and Ghazitabar, A. “Hydrochemically Separation of Gold from Copper Anode Slime by Means of Thiourea Solution.” Journal of Advanced Materials and Processing, 5, No. 2, (2017), 22-31.
  27. Javanshir, S., Abdollahy, M., and Abolghasemi, H. “Drop Size Distribution in A Mixer-Settler Reactor for the Gold Chloride/Dbc System.” Chemical Engineering Research and Design, 90, No. 8, (2012), 1680-1686 doi: 10.1016/j.cherd.2012.01.011
  28. Shojaei, M.R., Khayati, G.R., Assadat Yaghubi, N., Bagheri Sharebabaki, F., and Khorasan, S.M.J., “Removing of Sb and As from Electrolyte in Copper Electrorefining Process: A Green Approach.” International Journal of Engineering, Transactions C: Aspects, 34, No. 3, (2021), 700-705. doi: 10.5829/ije.2021.34.03c.14.
  29. Khazaei Feizabad, M.H., Khayati, G.R., Kafi Hernashki, R., Khorasani, and S.M.J., “Modeling and Optimization of Charge Materials Ranges in Converter Furnace with Enhanced Passivation Time in Copper Electrorefining Process: A Mixture Design Approach.” International Journal of Engineering, Transactions A: Basics, 34, No. 4, (2021), 966-975. doi: 10.5829/ije.2021.34.04a.23.
  30. Kilic, Y., Kartal, G., and Timur, S., “An Investigation of Copper and Selenium Recovery from Copper Anode Slimes.” International Journal of Mineral Processing, Vol. 124, No. 10, (2013), 75-82, doi: 10.1016/j.minpro.2013.04.006.
  31. Dönmez, B., Celik, C., Colak, S., and Yartaşi, A., “Dissolution Optimization of Copper from Anode Slime in H2SO4” Industrial & Engineering Chemistry Research, Vol. 37, No. 8, (1998), 3382-3387, doi: 10.1021/ie9800290.
  32. Seisko, S., Aromaa, J., Latostenmaa, P., Forsen, O., and Lundstrom, M., “Effect of Process Variables on Oxidative Pressurized Acid Leaching of Copper Electrorefining Anode Slimes.” In E3S Web of Conferences, Vol. 8, 01006, (2016), EDP Science.
  33. Seisko, S., Aromaa, J., Latostenmaa, P., Forsen, O., Wilson, B., and Lundström, M. “Pressure Leaching of Decopperized Copper Electrorefining Anode Slimes in Strong Acid Solution.’ Physicochemical Problems of Mineral Processing, Vol. 53, No. 1, (2017), 465-474, doi: doi.org/10.5277/ppmp170136
International Journal of Engineering
Volume 36, Issue 5
TRANSACTIONS B: Applications
May 2023
Pages 934-945

Files

Share

How to cite

Statistics