Abstract




 
   

IJE TRANSACTIONS C: Aspects Vol. 28, No. 12 (December 2015) 1738-1745   

PDF URL: http://www.ije.ir/Vol28/No12/C/6-2149.pdf  
downloaded Downloaded: 131   viewed Viewed: 2173

  A NEW TRANS-ADMITTANCE-MODE BIQUAD FILTER SUITABLE FOR LOW VOLTAGE OPERATION
 
S. V. Singh, R. S. Tomar and D. S. Chauhan
 
( Received: February 25, 2015 – Accepted: December 24, 2015 )
 
 

Abstract    The trans-admittance-mode (TAM) might act as a transforming bridge for voltage-mode to current-mode conversion. In this study a new low voltage operated electronically tunable TAM biquad filter structure realizing all the seven standard filtering functions namely; low-pass (LP), band-pass (BP), high-pass (HP), regular-notch (RN), low-pass-notch (LPN), high-pass-notch (HPN) and all-pass (AP) from the same configuration through appropriate selection of voltage inputs is presented. The proposed circuit structure comprises of three current conveyor trans-conductance amplifiers (CCTAs). Moreover, the new biquad filter structure still enjoys (i) realizations neither require inverted nor scaled voltage input(s), (ii) the employment of two grounded capacitors (Ideal for IC implementation and attractive for absorbing shunt parasitic capacitances), (iii) the pole frequency can be tuned electronically, (iv) possesses low incremental active and passive sensitivity performance and useful in low-voltage low-power applications. PSPICE simulation results using 0.25μm TSMC CMOS parameters verify the theoretical analysis.

 

Keywords    Analog signal processing, Biquad, Filter, Transadmittance-mode.

 

چکیده    ترانس حالت عبوری (TAM) می­تواند به عنوان یک پل برای تبدیل حالت ولتاژ به تبدیل حالت جریان عمل کند. در این مطالعه یک فیلتر جدید کم ولتاژ TAM الکترونیکی با ساختار biquad با استفاده از تمام هفت نوع تابع استاندارد فیلتر یعنی: پایین گذر (LP)، باند گذر (BP)، بالا گذر (HP)، شکاف معمولی (RN)، شکاف معمولی پایین گذر (LPN)، شکاف معمولی بالا گذر(HPN) و تمام گذر (AP) از همان پیکربندی از طریق انتخاب مناسب سیگنال­های ورودی ولتاژ ارائه شده است. ساختار مدار پیشنهادی شامل سه ترانس تقویت جریان CCTAs) است. علاوه بر این، ساختار فیلتر biquad جدید: (1) نه نیاز به معکوس کردن، و نه کوچک کردن ولتاژ ورودی (2) به کارگیری دو خازن، و از این رو فراهم ساختن ساختار متعارف مخروطی، (3) امکان تنظیم الکترونیکی فرکانس قطب، و(4) دارا بودن حساسیت فعال و غیر فعال کم و مفید در برنامه های کاربردی ولتاژ و قدرت پایین است. نتایج شبیه سازی PSPICE با استفاده از پارامترهای 0 CMOS TSMC μm 25 /0 تحلیل نظر را تایید می­کند.

References   

 

1.        Minaei, S., Topcu, G. and Cicekoglu, O., “Low input impedance trans-impedance type multifunction filter using only active elements”, International Journal of Electronics, Vol. 92, (2005), 385-392.

2.        Keskin, A. Ü., Biolek, D., Hancioglu, E. and Biolkova, V., “Current-mode KHN filter employing current differencing transconductance amplifiers”, International Journal of Electronics and Communications (AEU), Vol. 60, (2006), 443-446.

3.        Soliman, M., “Mixed-mode biquad circuits”, Microelectronics Journal, Vol. 27, (1996), 591-596.

4.        Kilinc, S. and Cam, U., “Trans-impedance type fully integrated biquad filter using operational trans-resistance amplifier”, Analog Integrated Circuits and Signal Processing, Vol. 47, (2006), 193-198.

5.        Maheshwari, S., Singh, S. V. and Chauhan, D. S., “Electronically tunable low voltage mixed-mode universal biquad filter”, IET Circuits, Devices and Systems, Vol. 5, (2011), 149-158.

6.        Tangsrirat, W., “Single input three output electronically tunable universal current-mode filter using current follower trans-conductance amplifiers”, International Journal of Electronics and Communications (AEU), Vol. 65, (2011), 783-787.

7.        Farshidi, E., Keramatzadeh, A., “A new approach for low voltage CMOS based on current-controlled conveyors”, International Journal of Engineering TRANSACTIONS B: Applications, Vol. 27, No. 5, (2014),723-730.

8.        Herencsar, N., Koton, J., Vrva, K. and Lattenberg, I., “Current follower trans-conductance amplifier (CFTA)- a useful building block for analog signal processing”, Journal of Active and Passive Electronic Devices, Vol. 6, (2011), 217-219.

9.        Minaei, S. and Türköz, S., “Current-mode electronically tunable universal filter using only plus-type current controlled conveyors and grounded capacitors”, ETRI Journal, Vol. 26, No. 4, (2004), 292-296.

10.     Tomar, R. S., Singh, S. V. and Chauhan, D. S., “Cascadable low voltage operated current-mode universal biquad filter,” WSEAS Transactions on Signal Processing, Vol. 10, (2014), 345-353.

11.     Senani, R., Singh, V. K., Singh, A. K. and Bhaskar, D. R., “Novel electronically controllable current mode universal biquad filter”, IEICE Electronics Express, Vol. 1, (2004), 410-415.

12.     Maheshwari, S., and Khan, I. A., “New voltage-mode universal filter using two CDBAs”,  Journal of Circuits, Systems and Computers, Vol. 14, No. 1, (2013), 159-164.

13.     Horng, J. W., Chiu, T. Y., Hsiao, C. P. and Huang, G. T., “Three input one output current-mode universal biquad using two current conveyors”, Journal of Circuits, Systems and Computers, Vol. 22,  No. 9, (2013).

14.     Herencsar, N., Koton, J. and Vrva, K., “Single CCTA-Based universal biquad filters employing minimum components”, International Journal of Computer and Electrical Engineering, Vol. 1, (2009), 307-310.

15.     Tomar, R. S., Singh, S. V. and Chauhan, D. S., “Current-processing current tunable universal biquad filter employing two CCTAs and two grounded capacitors,” Journal of Circuits and Systems, Vol. 4, (2013), 443-450.

16.     Thosdeekoraphat, T., Summart, S., Saetiaw, C., Santalunai, S. and Thongsopa, C., “Resistor-less current-mode universal biquad filter using CCTAs and grounded capacitors,” World Academy of Science, Engineering and Technology, Vol. 69, (2012), 559-563.

17.     Singh, S. V., Tomar, R. S. and Chauhan, D. S., “Single CCTA-based four input single output voltage-mode universal biquad filter”, International Journal of Computer Science and Information Security, Vol. 11, No. 3, (2013), 115-119.

18.     Singh, S. V., Tomar, R. S., and Chauhan, D. S., “Electronically tunable voltage-mode multifunction biquad filter using single CCTA”, IEEE International Conference on Signal Processing and Communication (ICSC-2013, JIIT Noida), (2013), 366-371.

19.     Cam, U., “A new transadmittance type first-order all pass filter employing single third generation current conveyor”, Analog Integrated Circuits and Signal Processing, Vol. 43, No. 1, (2005), 97-99.

20.     Toker, Cicekoglu, O., Ozacan, S. and Kuntman, H., “High output impedance transadmittance type continuous time multifunction filter with minimum active elements”, International Journal of Electronics, Vol. 88, No. 10, (2001), 1085-1091.

21.     Shah, N. A., Iqbal, S. Z. and Parveen, B., “SITO high output impedance transadmittance filter using FTFNs”, Analog Integrated Circuits and Signal Processing , Vol. 40, No. 4, (2004), 87-89.

22.     Bhaskar, D. R., Singh, A. K., Sharma, A. K. and Senani, R., “New OTA-C universal current-mode/trans-admittance biquads”, IEICE Electronics Express, Vol. 2, (2005), 8-13.

23.     Singh, S. V., Maheshwari, S., Mohan, J. and Chauhan, D. S., “An electronically tunable SIMO biquad filter using CCCCTA,” Contemporary Computing, CCIS , Vol. 40, (2009), 544-554.

24.     Prasad, D., Srivastava, M. and Bhaskar, D. R., “Trans-admittance type universal current-mode biquad filter using VDTAs”, International Scholarly Research Notices, Vol. 2014, (2014), 1-4.

25.     Ibrahim, M. A. and Kuntman, H., “A Novel transadmittance-type biquad employing DO-OTA with only two grounded capacitors”, In Proceedings of IEEE 13th International Conference on Signal Processing and Communications Applications, (2005), 119-122.

26.     Pandey, N., Paul, S. K., “SIMO trans-admittance-mode active-C universal filter”,  Journal of Circuits and Systems, Vol. 1, (2010), 54-58.

27.     Beg, P., Maheshwari, S. and Siddiqi, M., “Digitally controlled fully differential voltage- and transadmittance-mode biquadratic filter”, IET Circuits, Devices and Systems, Vol. 7, (2013), 193-203.

28.     Shah, N. A., Quadri, M. and Iqbal, S. Z., “CDTA based universal transadmittance filter”, Analog Integrated Circuits and Signal Processing, Vol. 52, No. 1-2, (2009), 65-69.

29.     Azhari, S. J., Safari, L., “Fully Differential current buffers based on a novel common mode separation technique”, International Journal of Engineering TRANSACTIONS B: Applications, Vol. 24, No. 3, (2011), 237-249.

30.     Biolek, D., Senani, R., Biolkova, V., and Kolka, Z., “Active elements for analog signal processing: classification, review, and new proposal”, Radioengineering Journal, Vol. 17, No. 4, (2008), 15- 32.

31.     Prokop, R. and Musil, V., “New modular current devices for true current mode signal processing”, Electronics, Vol. 16, No. 4, (2007), 36-42

32.     Jaikla, W., Silapan, P., Chanapromma, C. and Siripruchyanun, M. “Practical implementation of CCTA based on commercial CCII and OTA”, International Symposium on Intelligent Signal Processing and Communication Systems (ISPACS 2008). Thailand, (2008), 1-4.

33.     Tangsrirat, W. “Bi-CMOS CCCTA design and resistorless analog filter realization”, The Scientific World Journal, Vol. 2014, Article. 423979, (2014), 1-7.

34.     Lahiri, A. “Explicit-current-output quadrature oscillator using second-generation current conveyor transconductance amplifier”, Radioengineering Journal, Vol. 18, No. 4, (2009), 522–526.

35.     Prommee, P., Angkeaw, K., Somdunyakanok, M. and Dejhan, K., “CMOS- based near zero-offset multiple inputs max-min circuits and its applications”, Analog Integrated Circuits and Signal Processing, Vol. 61, (2009), 93-105.

36.     Fallah, M., Naimi, H. M., “A novel low voltage low power and high gain operational amplifier using negative resistance and self cascade transistors”,  International Journal of Engineering TRANSACTIONS C: Aspects,  Vol. 26, No. 3, ( 2013) , 303-308


Download PDF 



International Journal of Engineering
E-mail: office@ije.ir
Web Site: http://www.ije.ir