TY - JOUR ID - 92508 TI - Influence of Water Cooling on Orthogonal Cutting Process of Ti-6Al-4V Using Smooth-Particle Hydrodynamics Method JO - International Journal of Engineering JA - IJE LA - en SN - 1025-2495 AU - Dehghani, M. AU - Shafiei, A. R. AD - Department of mechanical Engineering, Yazd University, Yazd, Iran Y1 - 2019 PY - 2019 VL - 32 IS - 8 SP - 1210 EP - 1217 KW - Orthogonal Cutting Process KW - cooling KW - Smooth Particle Hydrodynamic DO - 10.5829/ije.2019.32.08b.18 N2 - Temperature control during the cutting process with different parameters such as cutting velocity and applying water cooling is essential to decrease the cutting force, increase the life of the cutting tool and decrease the machined surface temperature of work-piece. In this research, the temperature of machined surface and the chip-tool interface in orthogonal cutting process of Ti-6Al-4V were investigated using smooth particle hydrodynamics (SPH) method. The effects of cooling with different speeds and temperatures of water flow on the temperature of these surfaces were studied. The non-cooling model is validated using experimental results. According to the results, a water flow with speed of 0.25 m/s at 20°C temperature causes a significant decreasing in the cutting force and the temperature on machined surface and chip-tool interface. UR - https://www.ije.ir/article_92508.html L1 - https://www.ije.ir/article_92508_58afd534129f6d716aeca9ca953148f3.pdf ER -